NX 7.5 & 8 Graphics Display Problem

If you notice the problem of Graphics Display, especially in sketch dimensions. It is a problem that sketch dimensions will appear as zig zag lines, dimensions will be clumsy and values cannot be read unless we try to edit them. The possible reasons are:

(i) One reason is if we install 32bit version of NX on a 64bit computer, it is more likely to cause the graphics problem and vice-versa.

(ii) If the Graphics capacity of the computer is not sufficient to run NX, we will notice this problem. But this will be more on 3D geometry like solids and surfaces. Even the wireframe geometry will not be proper. Sketch dimensions are expected to appear correctly in this case.

For further help you may contact Siemens Global Technical Access Center (GTAC).